You can view the table of route maps in a CPE template and on a CPE device:
To view the table of route maps in a CPE template, go to the SD-WAN → CPE templates menu section, click the CPE template, and select the Routing filters → Route maps tab.
To view the table of route maps on a CPE device, go to the SD-WAN → CPE menu section, click the CPE device, and select the Routing filters → Route maps tab.
Information about route maps is displayed in the following columns of the table:
Name is the name of the route map.
Inherited indicates whether the route map is inherited from the CPE template:
Yes.
No.
This column is displayed only on the CPE device.
Sequence is the sequence number of the rule in the route map. The rule with the lowest sequence number is the first to be applied to the IPv4 prefix by the route map.
Action is the action that the rule performs on the IPv4 prefix:
Permit allows the IPv4 prefix.
Deny blocks the IPv4 prefix.
Match type is the criterion that makes the route map apply the rule to the IPv4 prefix:
None applies the rule to all IPv4 prefixes.
Prefix-List applies the rule to IPv4 prefixes allowed by the specified prefix list.
Value is an IPv4 prefix that the prefix list must allow for the route map to apply the rule to the IPv4 prefix. This column displays a value only if the Match type column displays Prefix-List.
Change attribute is the attribute whose value changes the rule.
New value is the value that the rule sets for the attribute.
Management contains the actions that can be performed with the route map.