Adding an address space

You can add address spaces to the application if you need to classify device addresses into sets according to some criterion (for example, based on devices belonging to network segments).

The maximum number of address spaces in the application is 100.

Only users with the Senior security officer role can add address spaces.

To add an address space:

1. Use the web interface to connect to the Central Node with the Senior security officer role.
2. Select the Assets section.
3. On the Address spaces tab, open the details area by clicking Add AS.
4. Enter the name of the address space.

   You can use letters, numbers, the space character, and the following special characters: ! @ # № $ % ^ & ( ) [ ] { } ' , . - _.

   The address space name must satisfy the following requirements:

   • Begins and ends with any character other than a space.
   • Contains up to 255 characters.
   • Does not reuse the name of another address space (case-insensitive).

   We recommend using address spaces 6–8 characters long or less. If the name is too long, the address information may not fit in the cells of some data tables (for example, in the table of devices).

5. If necessary, enter a text description of the address space.
6. Configure the settings of the first address space rule.
7. If necessary, add and configure additional address space rules by clicking Add rule.

   The total number of rules in an address space cannot exceed 10.

8. Click Save.

   This button is unavailable if not all required settings are specified, or if some settings are invalid.

The lower part of the Address spaces tab will show a separate block containing information about the added address space.

Page top